baxter Hillrom pro+ - Cpr; Transport

84 pro+ Surface Instruction for Use (209196 REV 8)
CPR
CPR
WARNING:
Warning—Use the bed CPR controls to put the bed in to the CPR position.
Failure to do so could cause patient injury.
For CPR, use the bed CPR controls. See the bed’s user manual.
Put a CPR board under the patient to provide support while performing
CPR on a patient in the bed.
TRANSPORT
WARNING:
Warning—Stow the MCM status indicator and surface power cord during
bed transport. Otherwise, patient injury could occur.
Before you transport the bed, do these (if applicable):
•Put the MCM status indicator between the footboard and
surface.
• Correctly stow any power cords and other equipment.
a. Make sure the patient’s heels are
toward the foot end of the surface.
b. Make sure the patient is centered on the surface.
c. If the bed has the FlexAfoot Retractable Foot Mechanism, set
the heel section for the patient’s height (see the bed’s user
manual).