pro+ Surface Instruction for Use (209196 REV 8) 69
900 Beds
(Warnings continued) To help prevent injury and/or equipment damage,
obey these warnings:
• Warning—The surface weighs
approximately 50 lb (22.7 kg).
Lift and move the surface with
the handles. Do not twist, and
seek assistance when
necessary.
9. Use the pro+ surface handles on
the side of the surface, to lift and
install the surface on the bed. Make
sure the logo side is up and at the
foot end of the bed.
10. Put the bed in this configuration:
• Bed in the highest position
• Knee in the highest position
• Head in the highest position
Step 2: Route the Surface Power Cord
Warning—Failure to route the surface power cord correctly could create
a tripping hazard and/or the cord to be pinched during bed functions.
Injury and/or equipment damage could occur.
The surface power cord is
routed along the patient-right
side of the 900 Bed.
To Next Page
Loading...
