pro+ Surface Instruction for Use (209196 REV 8) 75
900 Beds
34. If the bed has a scale system, zero the scale. See the bed’s user
manual.
Warning—Put the power cord in a location where persons will not
trip over it, and away from bed mechanisms. Failure to do so could
cause injury or equipment damage.
35. Make sure the power cord is in a position where persons will not trip
over it, and away from bed mechanisms.
1.6 LI900B3
Step 1: Setup
1. Make sure the brake is set on the bed.
2. Plug the bed into AC power.
3. Adjust the bed to the flat position.
4. Put the bed in the lowest position.
5. Lower the siderails.
6. If applicable, remove the surface (see the bed’s service manual).
7. Make sure the folding foot-end
surface clamp is in the up position.
8. Lift the pro+ surface to make sure
the surface power cord is routed
through the strap on the bottom
cover.
To Next Page
Loading...
