68 pro+ Surface Instruction for Use (209196 REV 8)
900 Beds
1.5 LI900B2
Step 1: Setup
1. Make sure the brake is set on the bed.
2. Plug the bed into AC power.
3. Adjust the bed to the flat position.
4. Put the bed in the lowest position.
5. Lower the siderails.
6. If applicable, remove the surface (see the bed’s service manual).
7. Raise the folding surface clamp at
the foot end of the bed.
8. Lift the pro+ surface to make sure
the surface power cord is routed
through the strap on the bottom
cover.
To help prevent injury and/or equipment damage, obey these
warnings:
• Warning—Make sure the surface is installed correctly. Failure to
do so could cause the bed not to articulate as intended.
To Next Page
Loading...
