60 pro+ Surface Instruction for Use (209196 REV 8)
CAREASSIST and ADVANTA 2 Beds
12. Route the surface power cord
between the head and seat sections
on the right-side of the bed.
13. Attach two cord magnets to the
upper frame below the head
section on the foot-end side of the
siderail mount.
14. Attach one magnet to the upper
frame below the head section on
the head-end side of the siderail
mount.
15. Put the bed power cord into the
cord clamp that is on the surface
power cord. Use the knob to
tighten the cord clamp.
Gently pull on the bed power cord
to make sure the cord clamp is
attached to the bed power cord.
To Next Page
Loading...
