82 pro+ Surface Instruction for Use (209196 REV 8)
900 Beds
29. Make sure the folding foot-end
surface clamp is in the up position.
30. If applicable, make sure the x-ray
sleeve zipper is closed on both
sides of the surface.
31. Make sure the bed is plugged into AC power.
Warning—Do not allow the surface to stay in continuous contact
with the headboard. This could impact the scale accuracy and Bed
Exit performance which could cause patient injury.
32. Make sure the surface does not stay in continuous contact with the
headboard.
33. If the bed has a scale system, zero the scale. See the bed’s user
manual.
Warning—Put the power cord in a location where persons will not
trip over it, and away from bed mechanisms. Failure to do so could
cause injury or equipment damage.
34. Make sure the power cord is in a location where persons will not trip
over it, and away from bed mechanisms.
To Next Page
Loading...
