Cleaning and disinfection
7990044_030_10 – 2078511 – 2023-01-19 77
7. Clean all residues from the uppermost side of the pad. Wipe
the sides of the pad again.
8. Leave the pads on the resting surface until dry. Also ensure
that the Velcro tape is completely dry.
9. Wipe the surface of the operating tabletop and the individual
tabletop sections so there are no residues.
10. Wipe the side rails on the operating tabletop and the tabletop
sections so there are no residues.
Once the upper surface of the tabletop sections is visibly dry, the
tabletop sections can be removed one by one.
11. Remove the individual tabletop section at the foot end of the
operating table and place it with the clean, dry side facing
downward on the prepared resting surface.
12. Clean the uppermost side and the hook couplings of the
tabletop section so there are no residues.
13. Move the hook couplings on the operating table all the way
up and clean them to remove any residue. Then move the
hook couplings all the way down and clean again so there are
no residues.
14. Remove the individual tabletop section at the head end of the
operating table and place it with the clean, dry side facing
downwards on the prepared resting surface.
15. Clean the uppermost side and the hook couplings of the
tabletop section so there are no residues.
To Next Page
Loading...
Need help?
General
