Learning Advanced Features
Used to switch equipment operation by connecting two
motors to one inverter. Configure and operate the second
motor when the input terminal is activated.
Commercial power
source transition
Used to switch the power source to the motor from the
inverter output to a commercial power source, and vice
versa.
Used to control the cooling fan of the inverter.
Configure an output relay as a timer with On/Off delay
times.
Used to control the On/Off operation of an electro-
mechanical braking system.
Control the state of an output relay based on an analog
input value.
Press regeneration
prevention
Used during a press operation to handle motor
regeneration, by increasing the motor operating speed.
* Draw operation is an open loop tension control. This feature allows a constant tension to be
applied to the material that is drawn by a motor-driven device, by fine-tuning the motor speed
using operating frequencies that are proportional to a ratio of the main frequency reference.
To Next Page
Loading...
