Frequency setting with (internal) potentiometer and start
command with the keypad [RUN] key
Ensure that the first code of the Operation group is
selected, and code 0.00 (Reference frequency) is
displayed.
Press the [▲] key 3 times.
Move to the drv (command source) parameter in the
operation group
Press the [ENT] key.
The drv parameter is currently set to 1 (Fx/Rx1 start
command set from the terminal block).
Press the [▼] key to change the parameter value to 0
(Keypad), and then press the [ENT] key.
The parameter value will flash.
Press the [ENT] key once again.
The drv parameter is displayed again. The command
source (Start/Stop) input has been configured for the
keypad.
Press the [▲] key 1 times.
Move to the Frq (Frequency reference source) parameter.
Press the [ENT] key.
The Frq parameter in the Operation group is currently
set to 0 (keypad).
Press the [▲] key to change the parameter value to 4
(V0, Set frequency input to (internal) potentiometer), and
then press the [ENT] key.
The parameter value will flash.
Press the [ENT] key once again.
The Frq parameter will be displayed again. The frequency
input has been configured for the V0, potentiometer.
Press the [▼] key 4 times.
Move to the first code of the Operation group (0.00).
From here frequency setting values can be monitored
Adjust the (internal) potentiometer to increase or
decrease the reference frequency to 10 Hz.
Press the [RUN] key.
The RUN indicator light flashes and the FWD indicator
light comes on steady. The accelerating frequency is
displayed.
When the frequency reaches the reference (10 Hz), press
the [STOP/RESET] key on the keypad.
The RUN indicator light flashes again and the
decelerating frequency is displayed.
When the frequency reaches 0 Hz, the RUN and FWD
indicator lights turn off, and the reference frequency,
10.00, is displayed again.
To Next Page
Loading...
