BENSHAW RSi GM2 Series - Monitoring the Operation; Output Current Monitoring

Perform Basic Operations
45
890054-00-00
GM2 Series VFD
Monitoring the Operation
Output Current Monitoring
The following demonstrates how to monitor the output current in the Operation group using the
keypad.
Step
Instruction
Keypad Display
1
Ensure that the first code of the Operation group is
selected, and code 0.00 (Reference frequency) is
displayed.
2
Press the [▲] or [▼] key to move to the CUr parameter.
3
Press the [ENT] key.
The output current (5.0 A) is displayed.
4
Press the [ENT] key once again.
Returns to the CUr parameter.
Note
You can monitor the RPM, dCL (DC link voltage monitor) and vOL (output voltage
monitor) parameters in the Operation group in the same way as shown in the example
above.
0.00
CUr
5.0
CUr