BENSHAW RSi GM2 Series - Table of Functions; Operation Group

Table of Functions
202
GM2 Series VFD
890054-00-00
Table of Functions
The following tables list the parameter groups and all the parameters within each group. Program
parameters according to your operating requirements.
The following messages may be displayed during programming of parameters when the [ENT] key
is pressed.
• rd: ReDo - value not allocated.
• OL: OverLap - An input is already programmed for the same function.
• no: Not Allowed - The set value is not allowed.
Parameters shaded in gray will be displayed when a related parameter has been selected.
The columns labeled “Property”, “V/F”, and “SL” show whether the parameter can be changed
while the inverter is running according to the following:.
O: Write enabled during run, X: Write Disabled during run, “-“ : Read only.
Additionally, columns “V/F” and “SL” refer to parameter dr.09, Control Mode settings.
V/F: Volts/Frequency Mode, SL: Sensorless Vector Mode
Operation Group
Code
Comm.
Address
Name
Display
Setting
Range
Initial
Value
Property*
V/
F
SL
Ref.
-
0h1D00
Target
frequency
0
0–Maximum
frequency (Hz)
0
O
O
O
p.40
-
0h1D01
Acceleration
time
ACC
0.0–600.0 (s)
5
O
O
O
p.67
-
0h1D02
Deceleration
time
dEC
0.0–600.0 (s)
10
O
O
O
p.67
-
0h1D03
Command
Source
drv
0
Keypad
1:Fx/Rx-1
X
O
O
p.62
1
Fx/Rx-1
2
Fx/Rx-2
3
Int 485
4
Fieldbus
1
-
0h1D04
Frequency
reference
source
Frq
0
Keypad-1
0:Keypad-
1
X
O
O
p.51
1
Keypad-2
2
V1
4
V0, built-in
volume
(potentiome
ter)
5
I2
6
Int 485
8
Field Bus
1
-
0h1D05
Multi-step
speed
frequency 1
St1
0.00–
Maximum
frequency (Hz)
10
O
O
O
p.60
-
0h1D06
Multi-step
speed
frequency 2
St2
0.00–
Maximum
frequency (Hz)
20
O
O
O
p.60