Mounting the Inverter
Mount the inverter on a wall or inside a panel following the procedures provided below. Before
installation, ensure that there is sufficient space to meet the clearance specifications, and that there
are no obstacles impeding the cooling fan’s air flow.
Select a wall or panel suitable to support the installation. Refer to 11.3 External Dimensions
on page 257 and check the inverter’s mounting bracket dimensions.
Use a level to draw a horizontal line on the mounting surface, and then carefully mark the
mounting holes.
Drill the two upper mounting bolt holes, and then mount the inverter with the top mounting
bolts. Do not fully tighten the bolts at this time. Fully tighten the mounting bolts after the
inverter has been mounted.
With the inverter temporarily installed, mark the location for the bottom mounting bolts.
Remove the inverter and drill holes for the bottom mounting bolts.
Mount the inverter on a wall or inside a panel using all mounting bolts. Fully tighten the upper
mounting bolts, then install two lower mounting bolts and tighten fully. Ensure that the
inverter is placed flat on the mounting surface, and that the installation surface can securely
support the weight of the inverter.
To Next Page
Loading...
