Learning to Use the Keypad
The keypad enables movement between groups and parameter codes. It also enables users to
select and configure functions. At parameter level, you can set parameter values and turn on or off
specific functions, or decide how the functions will be used. Refer to 8 Table of Functions on page
202 for a complete parmeter list.
Confirm the correct values (or the correct range of the values), and then follow the examples below
to configure the inverter with the keypad.
Group and Parameter Code Selection
Follow the examples below to learn how to switch between groups and parameter codes.
[MODE] button - Move to the group you want
using the [MODE] key. Press the [MODE] key for
longer than 1 second to move in the opposite
direction.
Up amd Down keys - [▲] and [▼] keys move up
and down through the parmeter codes within each
group. Locate the code that you require.
Press the [ENT] key to view the parameter setting.
The SET LED will be lit. Make changes using the Up
and Down keys. Press [ENT] again to save the
change and return to the parameter code.
Note When moving up and down through the codes using the [▲] and [▼] keys in each
group, there are cases where specific parmeter codes are not shown or will not increase or
decrease. This is because the parameter code is not set to be displayed (see example) or is
a view only parameter.
Example) If Ad.24 (frequency limit) code is set to 0 (No), Ad.25 (frequency lower limit
value) and Ad.26 (frequency upper limit value) codes will not be displayed. Ad.24
(frequency limit) code must be set to 1 (Yes) to display Ad.25 (frequency lower limit value)
and Ad.26 (frequency upper limit value) codes.
To Next Page
Loading...
