BENSHAW RSi GM2 Series - Navigating Directly to Different Codes (Jump Codes)

34
GM2 Series VFD
Perform Basic Operations
890054-00-00
Navigating Directly to Different Codes (Jump Codes)
The following examples detail navigating to code dr. 95, from the initial code in the Drive group (dr.
0). Using the arrow keys, pressing [UP] will loop backwards from dr.0 to dr.95. The table shows how
to program in the parameter number and jump directly to it. These examples apply to all groups
whenever you need to navigate to a specific parameter code number.
Using arrow keys:
Using Jump Code:
Step
Instruction
Keypad Display
1
Ensure that you are currently at the first code of the Drive
group (dr.0).
2
Press the [ENT] key.
Number "9" will flash.
3
Press the [▼] key and change the ones' place number to
"5", so the destination code is "5".
4
Press the [MODE] to move to the tens' place.
The cursor will move to the left and "05" will be displayed.
At this time, the number "0" will be flashing.
5
Press the [▲] key to change the tens' place number to "9",
so the destination code is "95".
6
Press the [ENT] key.
Code dr.95 is displayed.
9
5
05
95
dr.95
dr.0