BENSHAW RSi GM2 Series - Installing the Inverter

Installing the Inverter
8
GM2 Series VFD
890054-00-00
Installing the Inverter
This chapter describes the physical and electrical installation methods, including mounting and
wiring of the inverter. Refer to the flowchart and basic configuration diagram provided to
understand the procedures and installation methods to be followed to install the product correctly.
DIN Rail Mounting
The inverters include provisions for standard DIN rail (35mm x 7.5mm) mounting. If using DIN rail,
skip section 2.1, Panel / Wall Mounting.
Panel / Wall Mounting Installation Flowchart
The flowchart lists the sequence to be followed during installation. Install the product following the
flowchart and to test the operation. For more information on each step, refer to the pages below.
Product Identification (p.1 Ref.)
Select the Installation Location (p.4 Ref.)
Mounting the Inverter (p.10 Ref.)
Wiring the Ground Connection (p.15 Ref.)
Power and Signal Wiring (12)
Power and Signal Wiring (p.16 Ref.)
Post-Installation Checks (p.26 Ref.)
Turning on the Inverter
Parameter Configuration (p.35 Ref.)
Testing (p.28)