An example of braking resistor set up is as follows:
[Example 1]
[Example 2]
• T_acc: Acceleration time to set frequency
• T_steady: Constant speed operation time at set frequency
• T_dec: Deceleration time to a frequency lower than constant
speed operation or the stop time from constant speed operation
• T_stop: Stop time until operation resumes
Do not set the Enable Duty that will exceed the resistor’s power rating. If overloaded, it can
overheat and cause a fire. When using a resistor with a thermal switch, the switch output
can be used as an external trip input signal to the inverter or shunt trip the main breaker.
To Next Page
Loading...
