BENSHAW RSi GM2 Series - Page 41

Perform Basic Operations
31
890054-00-00
GM2 Series VFD
Key
Name
Function
ESC*
* Operates as ESC key when two keys are entered at
the same time.
- While in the group navigation mode, use ESC to go
to the initial screen (the frequency display screen).
- While in the parameter change mode (SET LED lit),
use ESC to go to group navigation mode without
saving.
Potentiometer
[Volume]
Used to set the reference frequency when parameter
Frq is set to 4 (V0).
Install a separate emergency stop switch in the circuit. The [STOP/RESET] key on the
keypad works only when the inverter has been configured to accept the stop command
from the keypad. Command Source parameter drv is set to 0 (Keypad).