BENSHAW RSi GM2 Series - Page 6

Table of Contents
vi
Frequency Reference Configuration .................................................................................. 51
Set the Frequency Reference from the Keypad - Direct Input ........... 51
Set the Frequency Reference from the Keypad - Using [▲] and [▼] keys 51
Set the Frequency Reference using the V1 Terminal ............................. 52
Set the Frequency Reference using V0, Built-in Potentiometer ......... 57
Setting the Reference Frequency using Input Current (I2) .................. 57
Setting the Frequency Reference using RS-485 Communication ..... 59
Frequency Hold by Digital Input ........................................................................................ 59
Multi-step Frequency Configuration ................................................................................. 60
Command Source (Start/Stop) Configuration ............................................................... 62
Setting the Keypad as a Command Input Device .................................... 62
Setting the Terminal Block as a Command Input Device - Fwd/Rev Run
Commands ............................................................................................................ 62
Setting the Terminal Block as a Command Input Device - Run and Rotation
Direction Commands ........................................................................................ 63
Setting RS-485 Communications as a Command Input Device ......... 64
Forward or Reverse Run Prevention .................................................................................. 64
Power-on Run ............................................................................................................................ 65
Reset and Restart ..................................................................................................................... 66
Setting Acceleration and Deceleration Times ................................................................ 67
Acc/Dec Time Based on Maximum Frequency ......................................... 67
Acc/Dec Time Based on Operating frequency ......................................... 68
Multi-step Acc/Dec Time Configuration ..................................................... 69
Acc/Dec Time Switch Frequency .................................................................... 71
Acc/Dec Pattern Configuration ........................................................................................... 72
Stopping the Acc/Dec Operation .................................................................................... 74
V/F Control ............................................................................................................................... 74
Linear V/F Pattern Operation .......................................................................... 74
Square Reduction V/F Pattern Operation ................................................... 76
User V/F Pattern Operation ............................................................................. 77
Torque Boost ........................................................................................................................... 78
Manual Torque Boost ......................................................................................... 78
Auto Torque Boost .............................................................................................. 79
Motor Output Voltage Adjustment ................................................................................ 80
Start Mode Setting ................................................................................................................ 80
Accelerating Start ................................................................................................ 80
DC Braking At Start ............................................................................................. 80
Initial Excitation (Pre-excite) ............................................................................ 82
Stop Mode Setting ................................................................................................................ 82