BENSHAW RSi GM2 Series - Page 66

56
GM2 Series VFD
890054-00-00
Learning Basic Features
Rotational Directions for Different Voltage Inputs
Run command
Input voltage
0–10 V
-10–0 V
FWD
Fwd
Rev
REV
Rev
Fwd
-10–+10 V Voltage Input Setting Details
Code and
Features
Description
In.12 V1 min.
Volt
In.13 % Output
at V1 min.
In.14 V1 max.
Volt
In.15 % Output
at V1 max.
These parameters are used to configure the offset and gradient level
(slope) values of the analog input to the required inverter output.
These parameters are displayed only when In.06 is set to 1 (bipolar).
• Set ln-12 to -2 V, set In.13 to 10%, set In.14 to -8 V, and In.15 to
80%. The output frequency will vary within the range of 6–48 Hz.