BENSHAW RSi GM2 Series - Page 9

ix
Table of Contents
Operation Mode on Option Card Trip ...................................................... 173
No Motor Trip .................................................................................................... 174
Low Voltage Trip 2 ........................................................................................... 174
Inverter pre-overheat warning .................................................................... 175
Torque Detection Protection Action ......................................................... 176
RS-485 Communication Features ........................................................................ 179
Communication Standards ................................................................................................ 179
Communication System Configuration ......................................................................... 181
Communication Line Connection ............................................................... 181
Setting Communication Parameters ......................................................... 182
Setting Start command and Frequency ................................................... 183
Command Loss Protective Operation ....................................................... 184
Setting Virtual Multi-function (digital) Input .......................................... 184
Saving Parameters Defined by Communication ................................... 185
Total Memory Map for Communication .................................................. 185
Parameter Group for Data Transmission ................................................. 185
Communication Protocol ................................................................................................... 186
Modbus-RTU Protocol .................................................................................... 186
WinDRIVE ................................................................................................................................. 189
Compatible Common Area Parameter .......................................................................... 192
GM2 Expansion Common Area Parameter .................................................................. 195
Monitoring Area Parameter (Read Only) ................................................. 195
Control Area Parameter (Read/ Write) ..................................................... 199
Memory Control Area Parameter (Read and Write) ............................ 200
Table of Functions ................................................................................................ 202
Operation Group ................................................................................................................... 202
Drive Group (PAR→dr) ........................................................................................................ 204
Basic Function Group (PAR→bA) ..................................................................................... 207
Advanced Function Group (PAR→Ad) ........................................................................... 211
Control Function Group (PAR→Cn) ................................................................................ 216
Input Terminal Block Function Group (PAR→In) ....................................................... 219
Output Terminal Block Function Group (PAR→OU) ................................................. 223
Communication Function Group (PAR→CM) ............................................................. 227
Application Function Group (PAR→AP) ........................................................................ 231