1-2 Introduction
Bio-Tek’s PowerWave may be configured with all, or selected options for
optimum performance:
• PowerWave 340 instruments are capable of reading plates at
wavelengths between 340 and 800 nm.
• I-model instruments have a four-zone incubation chamber which
controls temperature from 4° above ambient to 50° C.
• In addition, options such as an internal bar-code scanner and robot
friendly (RoboReader) are available.
Quality Control__________________________________________________
It is considered to be good laboratory practice to run laboratory samples
according to instructions and specific recommendations included in the
package insert for the test to be conducted. Failure to conduct Quality
Control checks could result in erroneous test data.
• Regulatory Agency Approvals :
The instrument has been tested, approved and externally labeled to show
compliance to the following test standards.
• ETL CAN/CSA - C22.2 No. 1010.1-92 EN 61010-1
• CE EN50081-1 (Emission)
EN61010-1 (Low Voltage Direction)
EN50082-1 (EMC Susceptibility)
• FCC Subpart 15 (EMI)
• Canadian Standards Association CAN/CSA C22.2 No. 1010.1-1992
Safety Requirements for Electrical Equipment for Measurement,
Control and Laboratory Use, Part 1: General Requirements
Accessories Included
• Operator’s manual
• Line cord for the country of use
• Dust Cover
• Parallel Cable
To Next Page
Loading...
