3-30 Operation
If NO is chosen, the stored standard curve will be used. If Auto mapping
had been used to originally map the standards, blanks, controls and samples
defined for this assay, the map will be automatically regenerated without
the standards, beginning in well xxx (where xxx was chosen as the Starting
well in the map, usually well A01). If Manual mapping was used to map the
plate, the map is NOT regenerated - the reader will NOT produce results for
the well positions that originally were standards. Auto mapping is
recommended, if the standards curves will be routinely re-used.
NUMBER OF CONTROLS
The Number of Control screen (Figure 3-38) allows the user to enter the
number of controls that will be used in the assay. Any previously defined
value will appear on the display.
E
N
T
E
R
U
M
B
E
R
O
F
C
O
N
T
R
O
L
S
: 2
Figure 3-38: Number of Controls screen
• Use the NUMERIC keys to enter the Number of Controls. The
range depends on the number of locations on the plate that are
undefined. The maximum number of controls is 8.
To Next Page
Loading...
