PowerWave Operator’s Manual 3-29
To reuse a standard curve, an assay must first be programmed ( in positions
51-55) and run. During the defining process, the user will be prompted to
enter the number of standards, the number of standard replicates and the
standard concentrations ( Refer to pages 3-17 through 3-20). The following
screen has been added after these prompts:
R
E
U
S
E
S
T
A
N
D
A
R
D
C
U
R
V
E
?
Y
E
S
Y
E
S
N
O
Figure 3-35: Reuse Standard Curve screen
After the assay has been run, the results have been calculated, and the
reports have been generated, the reader will prompt if this standard curve
should be stored in memory. The following display will appear (Figure 3-36):
S
A
V
E
S
T
A
N
D
A
R
D
C
U
R
V
E
?
Y
E
S
Y
E
S
N
O
Figure 3-36: Save Standard Curve screen
Choosing YES will store the curve to be used at a later time. The next time
this assay is used, the instrument will prompt if there are standards on the
plate (Figure 3-37).
S
T
A
N
D
A
R
D
S
O
N
P
L
A
T
E
?
N
O
Y
E
S
N
O
Figure 3-37: Standards on Plate screen
If YES is chosen, a new standard curve will be generated. The plate map is
not changed. (If “Prompt for Sample ID” is enabled in UTIL section, the user
will be prompted to enter the number of samples - see page 2-20 for more
information on the UTIL options.)
To Next Page
Loading...
