IQC 5000B Operation Manual
75
Routine Maintenance and Cleaning
To prevent the buildup of dust and keep air flowing as well as possible, a routine cleaning of the IQC5000 and
peripheral devices every 3 months is recommended. A simple but thorough cleaning with a can of gas duster
(canned air) around air inlets should be performed. The location of air inlets, further maintenance steps, and
maintenance schedule are outlined in Table 27.
Before performing maintenance,
p
ower down each component.
Table 27 - Cleaning Instructions
Unit
Air Inlet
Lo
cat
ion
Cleaning Instructions Schedule
IQC5000 Left and right sides Clean air inlets with gas duster Every 3 Months
IQC-MEM Left and right sides Clean air inlets with gas duster Every 3 Months
External Storage
Uni
t
Front and back
Clean air inlets with gas duster, making sure to open the front
latch and spray the front latch filter from the inside out
Every 3 Months
Check that retaining strip on inside of front latch has not shifte
d Every 3 Months and
after transport
Check that drives are securely sea
ted by firmly pushing each
drive from the front
After transport
All other
periphera
ls
Perform maintenance according to manufacturer’s instructions
System Temperatures
Important internal components are monitored for temperature via the IQC Control software. These values should be
monitored to ensure system has proper cooling and to avoid overheating. The internal temperatures can be view of
the System Tab in IQC control, see "System Temperatures" on page 48.
To Next Page
Loading...
