Blue Sonic Multimedia PC - HDMI-In Port in Sleep or Hibernate Modes

To Next Page

To Previous Page

HDMI-In Port 1 - 15

Quick Start Guide

HDMI-In Port in Sleep or Hibernate Modes

Note that if the computer is in Sleep or Hibernate modes, and no HDMI cable is plugged-in, then the procedure

for plugging-in the HDMI cable and using the system as a display device is as follows:

1. The System is in Sleep or Hibernate mode and no HDMI cable is plugged-in.

2. The battery/HDMI icon will be off.

3. Plug-in the HDMI cable.

4. The battery/HDMI icon will turn green for about 8 seconds and then turn off again.

5. Press the Mode Toggle Button .

6. The battery/HDMI icon will turn green again.

7. After a few seconds the system will display the image from the external HDMI source.