Bosch CRI 848H - Fitting Trigger Electronics

1 689 989 087 2018-07-24| Robert Bosch GmbH
70 | CRI/CRIN 848H | Initial startupen
4.5 Fitting trigger electronics
1. Slacken off the hexagon bolts (Fig. 31, item 1).
2. Slide the mounting bracket (Fig. 31, item 2) to the
rear.
1
2
458847-12_Pal
Fig. 32: Frame with mounting bracket
3. Slacken off the hexagon bolts (Fig. 33, item 3).
4. Place the trigger electronics (Fig. 33, item 4) on the
two hexagon bolts.
5. Tighten the hexagon bolts (Fig. 33, item 3).
3
4
458847-14_Pal
Fig. 33: Fitting trigger electronics
6. Slide the mounting bracket (Fig. 34, item 2) for-
wards.
7. Tighten the hexagon bolts (Fig. 34, item 1).
1
2
458847-13_Pal
Fig. 34: Setting mounting bracket