Solution 6000-IP
Installation Manual Comms Programming
9-8
Bosch Security Systems 10/22 BLCC615I
Comms > IP Reporting >
Retry Count
MENU 5-6-5
0 3
This menu allows the installer to program the number of
attempts that the system will try to communicate via TCP/
IP to the base station receiver for both Destination 1 and/
or Destination 2. The retry count can be programmed
between 01 and 15 (00=Disabled).
1) Press [MENU] + [5] + [6] + [5]. The keypad will
prompt you to select which destination
(destination 1 or 2) that you want to program the
acknowledge wait time.
Rr1 Dest 1
Rr2 Dest 2
Exit
Press OK or MENU
2) Highlight the destination number (1 or 2) required,
then press [OK] to select.
The keypad will display the current retry count.
Retry Count Rr1
3
Press 0-9 OK to SAVE
3) Use the numeric keys [0] to [9] to program the new
retry count, then press [OK] to save and exit or
press [MENU] to exit without saving.
Comms > IP Reporting >
Encryption Key
MENU 5-6-6
Dest Nº 1
1 Digits 32
0 0 0 0 0 0 0 0 0 0 0 0 0
Dest Nº 2
1 Digits 32
0 0 0 0 0 0 0 0 0 0 0 0 0
The encryption key must match the encryption key on the
base station receiver for communication to take place. To
remove encryption, set MENU 6-6-4 as all zero’s.
1) Press [MENU] + [5] + [6] + [6]. The keypad will
prompt you to select which destination
(destination 1 or 2) that you want to program the
acknowledge wait time.
Rr1 Dest 1
Rr2 Dest 2
Exit
Press OK or MENU
2) Highlight the destination number (1 or 2) required,
then press [OK] to select.
The keypad will display the current encryption key.
Encryption Key Rr1
0000000000000000000
Press OK to SAVE
3) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 32 digitencryption key, then press
[OK] to save and exit or press [MENU] to exit
without saving.
Comms > IP Reporting >
Conettix NNC
MENU 5-6-7
Dest Nº 1 0 0 0 0 0 0 0 0
Dest Nº 2 0 0 0 0 0 0 0 0
The NCC number is used to prevent anti-replay attacks
when reporting in Connetix format. The NNC number will
be assigned by the control room at the time the account
is setup. Like the account number, the NNC will always be
unique.
1) Press [MENU] + [5] + [6] + [7]. The keypad will
display the first 6 digits of the current NNC number.
Conettix NNC Rr1
00000000
Press OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 8 digit NNC number, then press
[OK] to save and exit or press [MENU] to exit
without saving.
To Next Page
Loading...
Need help?
General
