Solution 6000-IP
Installation Manual System Programming
11-4
Bosch Security Systems 10/22 BLCC615I
Some other examples of the log are as follows:
1)
E202 Sun,01Apr 03:41:45
Disarmed by User
Area 1 Name
Ur1 User 1 Name
E202 Dest= SLL-----
Kp1 Keypad 1 Name
Panel 1
Dest 1 at 01-Apr 03:41:57
2)
E405 Sun,01Apr 06:41:45
Burglary Zone Bypassed
Area 1 Name
Zn3 Zone 3 Name
E405 Dest= SLL-----
Ur1 User 1 Name
Panel 1
Dest 1 at 01-Apr 06:41:57
The Dest= field displays the various reporting route
information for up to eight different reporting
destinations. Your installer will have configured these
during installation.
The following letters will be displayed in the eight
destination locations indicating the status of the report.
The log will also show the actual time a report was sent.
Dest =
S = Sent
L = Logged
P = Pending
F = Failed
A = Aborted
System > Commands >
Factory Default
MENU 7-0-4
This command will erase ALL programmable data and
return the control panel to factory default settings.
Defaulting the panel will NOT erase any history events
that are currently stored in the panel.
During a factory default both the Status and Dialler
LED indicators on the panel will flash very quickly to
indicate defaulting is still in progress.
1) Press [MENU] + [7] + [0] + [4]. The keypad will
display:
This command will ERASE
all panel programming. To
Continue press OK, or
MENU to cancel
2) Press [OK] to start the default process or press
[MENU] to cancel and exit.
3) The keypad will display the following message
during the default process and will exit back to the
menu when finished.
Defaulting System
..Please Wait..
System > Commands >
Template Default
MENU 7-0-5
This command is RESERVED.
To Next Page
Loading...
Need help?
General
