Branson S83 - User Manual

Questions and Answers

W
williammurrayJul 30, 2025
What to do if Overload LED is on for Branson S8500 Inverter?
- W
  Wendy GarciaJul 30, 2025
  If the Overload LED is illuminated on your Branson S8500 Inverter, it could be due to several reasons. First, ensure that the connected load, power, and frequency are compatible with the power supply. A faulty connection between the power supply and the load, a faulty component, or low line voltage can also trigger this. Check the model numbers of the tanks or immersible transducers. Inspect the RF cable and connecting cables for any open or short circuits. Confirm that the line voltage exceeds 190VAC.
K
Karl NewtonAug 3, 2025
How to fix Over temp LED on Branson S83?
- J
  Joshua HawkinsAug 3, 2025
  If the ambient air temperature exceeds 105°F or if the airflow to the cooling chamber is obstructed, the Over Temp LED on your Branson S8300 or S8500 Inverter may illuminate. To resolve this, move the ultrasonic power supply to a cooler location and ensure that there are no obstructions at the back of the unit.
H
hahnoliviaAug 8, 2025
Why are Sys Fault and/or RESET LEDs on Branson S83?
- J
  James GriffithAug 8, 2025
  The Sys Fault and/or RESET LEDs on Branson Inverter may indicate an incompatible load, power, or frequency connected to the ultrasonic power supply. Verify the model numbers of the tanks or immersible transducers to ensure compatibility.
K
Kaitlin SkinnerAug 11, 2025
What does Upper Limit or Lower Limit LED on Branson S8500 Inverter mean?
- S
  Samantha GlassAug 11, 2025
  If the Upper Limit or Lower Limit LED is on for Branson S8500 Inverter, it means a connected component may not have the same power or frequency rating, or the component itself is faulty. Check the model numbers of the power supply and all connected components. Troubleshoot or test the tank or immersible transducers and replace them if necessary.
D
davidmitchellAug 16, 2025
What does Ext Lock LED on Branson S8500 Inverter mean?
- B
  bentonmakaylaAug 16, 2025
  The Ext. Lock LED on Branson S8500 Inverter indicates that the RF cable is not connected to the ultrasonic power supply, or the Ext. Lock switch is closed through the I/O connector. Ensure the RF cable is properly connected and open the Ext. Lock switch.
A
Ashley LeAug 20, 2025
How to turn on sweep mode on Branson S8500 Inverter?
- A
  Austin WhitakerAug 20, 2025
  If you cannot turn sweep mode on your Branson S8500 Inverter, it is because the Power Modulation mode is active. Turn PWR MOD off to enable sweep mode.
F
Frederick JacksonAug 25, 2025
Why cannot I turn Power modulation on Branson S8500 Inverter?
- J
  Jordan CarrilloAug 26, 2025
  If you are unable to activate Power Modulation on your Branson S8500 Inverter, it's likely because Sweep mode is currently enabled. Deactivate SWEEP mode first.