2-68
Confidential
Error codes F100 to F800
These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
An unidentified error occurred.
Error code F900
The country code was not entered correctly.
Error codes FA00 to FF00
These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
An unidentified error occurred.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
Machine Error F9
-
Step Cause Remedy
1
Power switch was turned OFF
while "PARAMETER INIT" is
displayed during execution of
function code 74.
Reenter the country code.
(Refer to "1.3.23 Setting by country (function
code: 74)" in Chapter 5.)
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
