6
FLUID REQUIREMENTS
GENERAL
United States System
Unless otherwise specified,
all fluid volume measurements
in this Service Manual are expressed in United States
(U.S.) units-of-measure
. See below:
●
1 pint (U.S.) = 16 fluid ounces (U.S.)
●
1 quart (U.S.) = 2 pints (U.S.) = 32 fl. oz. (U.S.)
●
1 gallon (U.S.) = 4 quarts (U.S.) = 128 fl. oz. (U.S.)
Metric System
Fluid volume measurements in this Service Manual include
the metric system equivalents. In the metric system, 1 liter
(L) = 1,000 milliliters (mL). Should you need to convert from
U.S. units-of-measure to metric units-of-measure (or vice
versa), refer to the following:
●
fluid ounces (U.S.) x 29.574 = milliliters
●
pints (U.S.) x 0.473 = liters
●
quarts (U.S.) x 0.946 = liters
●
gallons (U.S.) x 3.785 = liters
●
milliliters x 0.0338 = fluid ounces (U.S.)
●
liters x 2.114 = pints (U.S.)
●
liters x 1.057 = quarts (U.S.)
●
liters x 0.264 = gallons (U.S.)
STEERING HEAD BEARING
GREASE
Use WHEEL BEARING GREASE (Part No. 99855-89).
BRAKE FLUID
1
WARNING
D.O.T. 5 SILICONE HYDRAULIC BRAKE FLUID can cause
eye irritation. In case of contact with eyes, flush with
plenty of water and get medical attention. KEEP BRAKE
FLUID OUT OF THE REACH OF CHILDREN!
Use only D.O.T. 5 SILICONE HYDRAULIC BRAKE FLUID
(Part No. 99902-77).
FRONT FORK OIL
Use only WP FORK OIL, 5 WEIGHT.
FUEL
Use a good quality leaded or unleaded gasoline (91 pump
octane or higher). Pump octane is the octane number usually
shown on the gas pump.
ENGINE OIL
Use the proper grade of oil for the lowest temperature
expected before the next oil change.
PRIMARY DRIVE/TRANSMISSION
LUBRICANT
Use only SPORT-TRANS FLUID (Part No. 98854-96 quart
size or Part No. 98855-96 gallon size).
Table 1. Recommended Oil Grades
HARLEY-
DAVIDSON TYPE
VISCOSITY
HARLEY-
DAVIDSON
RATING
LOWEST
AMBIENT
TEMP.
COLD
WEATHER
STARTS
BELOW
50
°
F
H.D. Multi-Grade
SAE
10W40
HD 240
Below 40
°
F
(4
°
C)
Excellent
H.D. Multi-Grade
SAE
20W50
HD 240
Above 40
°
(4
°
C)
Good
H.D. Regular Heavy
SAE
50
HD 240
Above 60
°
(16
°
C)
Poor
H.D. Extra Heavy
SAE
60
HD 240
Above 80
°
(27
°
C)
Poor
To Next Page
Loading...
Need help?
General
