INTELLIDOX DOCKING MODULE USER MANUAL || ASSEMBLE MODULES
BW TECHNOLOGIES BY HONEYWELL PAGE 21 OF 103
Removing Connected Modules from Mounted Back Panels
1. Disconnect the power cord, network cable, tubing and inlet filter assemblies.
2. Unlock and lift the latch arm between the two modules at the end of the gang.
3. Find the panel latch at the top right side of the module at the end of the gang.
4. Press down firmly on the panel latch, and then continue to press down while you push
the module to the right until the hinge pins and hooks are detached. For best results,
BW Technologies recommends that you hold the remainder of the gang firmly in
position while pushing to help protect the remaining modules in the gang from
excessive movement or falls.
5. Repeat steps 2, 3 and 4 until only one module remains.
6. Repeat steps 3 and 4 to remove the final module.
To Next Page
Loading...
Need help?
General