INTELLIDOX DOCKING MODULE USER MANUAL || CONFIGURE SETTINGS VIA FLEET MANAGER II SOFTWARE
BW TECHNOLOGIES BY HONEYWELL PAGE 65 OF 103
Adjusting the Clock for Daylight Savings Time
After the module time is set via Fleet Manager II software, you may use Fleet Manager II
to configure module and detector clocks to automatically adjust for daylight savings time.
1. Set the module time. See Setting the Module Time on page 63.
2. Select the tab for a compatible detector and then select the IntelliDoX Configuration
tab for the compatible detector.
3. Under Timezone Settings, select Automatically adjust clock for Daylight Savings
Time.
4. Click the Time zone selector and then select a time zone from the drop down menu.
The next start and end dates for daylight savings time are displayed for the specified
time zone.
5. Review and revise other configuration settings if necessary, and then save the
configuration file and transfer it to one or more modules. For more information, see
Configure Module and Detector Settings on page 60.
To Next Page
Loading...
Need help?
General