INTELLIDOX DOCKING MODULE USER MANUAL || PREPARE MODULES FOR USE
BW TECHNOLOGIES BY HONEYWELL PAGE 32 OF 103
Connecting the Module to a Network
Insert one end of the Ethernet cable into the Ethernet port on the module. Insert the free
end of the Ethernet cable into the network outlet. When the module is connected to the
network, the network symbol is displayed at the top right corner of the LCD.
If the network symbol is not displayed within several seconds, then follow these steps:
1. Verify that the module is activated.
2. Verify that one end of the Ethernet cable is fully inserted into the Ethernet port on the
module, and then verify that the free end is fully inserted into an active network outlet.
3. Press and hold until the Adjust docking station settings menu is displayed.
Press or to scroll to About, and then press to display the About screen. If
the IP address displays only zeroes, then the connection is not active.
If problems persist, contact your network administrator or Help Desk.
Connecting IntelliDoX to Fleet Manager
Fleet Manager’s versions older than FMSUMF_08_000 will not require a passcode to
access connect to IntelliDoX.
For newer Fleet Manager versions, Fleet Manager will require entering the Network
Passcode in order to add IntelliDoX. This will be a one time only process. Fleet Manager
will need to send the IntelliDoX the network passcode to verify the connection.
To Next Page
Loading...
Need help?
General