BW Technologies IntelliDoX - Replace the Detector Cradle

To Next Page

To Previous Page

INTELLIDOX DOCKING MODULE USER MANUAL || REPLACE DETECTOR CRADLE AND CALIBRATION INSERT

BW TECHNOLOGIES BY HONEYWELL PAGE 80 OF 103

Replace the Detector Cradle

To replace the cradle, remove the cradle from the IntelliDoX (unscrew the screws and

unplug the connector), and then install the replacement cradle.

1. Disconnect the power cord, network cable, tubing, and inlet filter assemblies from the

IntelliDoX.

2. Use a screwdriver to unscrew the two screws from the cradle.