INTELLIDOX DOCKING MODULE USER MANUAL || PREPARE MODULES FOR USE
BW TECHNOLOGIES BY HONEYWELL PAGE 30 OF 103
Connect the Power
Each IntelliDoX Enabler Kit contains one power supply and AC power cord. Use only the
power supply provided in the Enabler Kit to connect the module to an appropriate
electrical power outlet. When the power is connected, the module activates and a self-test
is performed.
Connecting the Power
1. Verify that the power supply and power cord provided in the Enabler Kit are
compatible with the local power source. If the power supply is not compatible, do not
attempt to connect the module to a power source. Contact BW Technologies or an
authorized distributor immediately.
2. Connect the AC power cord to the power supply.
3. Connect the power supply into the power connection on the module. Press firmly until
you hear a click. The click confirms that the plug is locked.
4. Plug the AC power cord into a suitable wall outlet.
5. When the power is connected, the LCD activates and a self-test is performed.
Disconnecting the Power
To deactivate a module or gang of modules, disconnect the power supply. The module or
gang of modules deactivates immediately and without warning.
1. Retract the plastic cover on the plug to unlock it.
2. While the cover is retracted, pull the plug out of the module.
To prevent the corruption or loss of data and/or software and/or firmware, do not
deactivate the equipment while performing datalog transfers, bump tests, calibrations
or other operations.
To Next Page
Loading...
Need help?
General