Canon IMAGECLASS LBP654CDW - Registering the Key and Certificate for Network Communication

Registering the Key and Certicate for Network
Communication
1648-086
You can obtain the key and certicate, and the CA certicate from a certication authority (CA) for use with the
machine. Install and register the obtained key and certicate le and CA certicate le in this machine using Remote
UI. Check the key and certicate, and CA certicate conditions that are required for the machine in advance (
Management Functions(P. 528) ).
● For more information about the basic operations to be performed when setting the machine from the
Remote UI, see Setting Up Menu Options from Remote UI(P. 283) .
1
Start the Remote UI and log in to System Manager Mode. Starting Remote
UI(P. 275)
2
Click [Settings/Registration] on the Portal page. Remote UI Screen(P. 276)
3
Select [Device Management] [Key and Certicate Settings] or [CA Certicate
Settings].
● Click [Key and Certicate Settings] to install a key and certicate, or [CA Certicate Settings] to install a CA
certicate.
4
Click [Register Key and Certicate] or [Register CA Certicate].
Deleting a registered key and certicate or CA certicate
● Click [Delete] on the right of the key and certicate or CA certicate you want to delete click [OK]. You
cannot delete the preinstalled CA certicates.
● A key and certicate cannot be deleted if it is currently used for some purpose, such as when "[TLS]" or
"[IEEE 802.1X]" is displayed under [Key Usage]. In this case, disable the function or replace the key and
certicate before deleting it.
Disabling or enabling the preinstalled CA certicates
● Click [Disable] on the right of the preinstalled CA certicate you want to disable. To enable the certicate
again, click [Enable] on the right of the certicate.
5
Click [Install].
Managing the Machine
255