<Reduce Toner Flaking>(P. 342)
● Setting a greater improvement effect may result in curled printouts or slower printing speed.
Are you using the machine in an environment with high humidity?
(LBP654Cdw)
● Setting <Reduce Toner Fixing Stain 2> to <Mode 2> may solve the problem.
<Reduce Toner Fixing Stain 2>(P. 343)
● If you set to <Mode 2>, printouts may be curled.
Is the machine installed in an environment where the temperature changes
rapidly and drastically?
● When the temperature changes rapidly in the environment where the machine is installed, condensation
occurs, which may cause fading or bleeding in images and text. If <Control Condensation> is set to <On>,
condensation inside the machine will be removed. Condensation removal may be performed automatically
due to temperature change.
<Control Condensation>(P. 346)
● While condensation removal is being performed, printing may not be performed properly and blank paper
may be output.
● If you set to <On>, you need to keep the machine turned ON to maintain the effect of condensation
removal.
A Portion of the Page Is Not Printed
Do you print data without margins?
● This symptom occurs if a margin is set to none in the printer driver. A margin of 1/4" (5 mm) or less
around the edge of paper or 3/8" (10 mm) or less around the edge of envelopes is not printable with the
machine. Make sure to have margins around the document to print.
[Finishing] tab [Advanced Settings] [Expand Print Region and Print] [Off]
Do the paper guides align with the edges of the paper?
● If the paper guides are too loose or too tight, part of a document may not be printed.
Troubleshooting
465
To Next Page
