Canon IMAGECLASS LBP654CDW - Configuring Wsd

Conguring WSD
1
Select [WSD Settings] [Edit].
2
Congure the settings as necessary.
[Use WSD Printing]
Select the check box to print via WSD. When not using WSD printing, clear the check box.
[Use WSD Browsing]
Select the check box to obtain information about the machine from a computer via WSD. This check box is
automatically selected when the [Use WSD Printing] check box is selected.
[Use Multicast Discovery]
Select the check box to set the machine to reply to multicast discovery messages. If the check box is
cleared, the machine stays in sleep mode even when multicast discovery messages are owing on the
network.
3
Click [OK].
5
Restart the machine.
● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Selecting settings from the operation panel
● LPD, RAW, and WSD, settings can also be accessed from <Menu> in the Home screen.
<LPD Settings>(P. 316)
<RAW Settings>(P. 316)
<WSD Settings>(P. 316)
Setting up WSD network devices
● The WSD network devices can be added from the printer folder. Open the printer folder ( Displaying the
Printer Folder(P. 543) ) click [Add a device] or [Add a printer] and follow the on-screen instructions. For
more information about how to install the driver for the WSD network, see the manuals for the relevant
drivers on the online manual website.
To change the port number
● The same port number used for the machine and a computer must be used for printing protocol.
Conguring Printer Ports(P. 54)
Changing Port Numbers(P. 243)
Setting Up
52