Canon IMAGECLASS LBP654CDW - Page 487

Could not perform cleaning.
Paper jammed during cleaning.
● Remove the jammed paper, set paper correctly, and perform cleaning again.
Clearing Paper Jams(P. 496)
Cleaning the Fixing Assembly(P. 425)
The amount remaining in toner cartridges required for cleaning the xing unit is insucient.
● Cleaning requires sucient toner cartridge remaining. Replace the toner cartridge, and perform the
cleaning again.
Procedure for Replacing the Toner Cartridge(P. 428)
Could not perform correction.
The amount remaining in toner cartridges required for correction is insucient.
● Corrections require sucient toner cartridge remaining. Replace the toner cartridge, and perform
correction again.
Procedure for Replacing the Toner Cartridge(P. 428)
The transfer belt inside the machine is dirty.
● Perform automatic cleaning of the transfer belt.
Cleaning the Transfer Belt (ITB)(P. 426)
Could not perform Open System authentication. Check the WEP settings./
Could not perform Open System auth. Check WEP settings.
The authentication method of the machine is set to <Open System>, but that of a wireless router is set to
"Shared Key."
● Connect again by manually changing the WEP authentication method to <Shared Key>.
Setting Up Connection by Specifying Detailed Settings(P. 36)
The MAC address of the machine is rejected because the MAC address lter is set at a wireless router.
● Set the wireless router to permit the MAC address of the machine and your computer. For more
information about how to set, see the instruction manuals for your networking devices or contact your
manufacturer. To check the MAC address of the machine, select <Menu>
<Preferences>
<Network> <Wireless LAN Settings> <Connection Information>.
Viewing the MAC Address for Wired LAN(P. 47)
Could not perform Shared Key authentication. Check the WEP settings./
Could not perform Shared Key auth. Check WEP settings.
The network key (the WEP key) of a wireless router to be connected is not set to the machine correctly.
● Check the network key (the WEP key) of the wireless router, and set it to the machine again.
Troubleshooting
481