Canon IMAGECLASS LBP654CDW - Page 494

● Make sure that you have a replacement toner cartridge ready. Replace the toner cartridge if you see this
message before you start to print a large job.
Consumables(P. 446)
Printing is restricted.
Printing is disabled in the Department ID Management.
● Log in with a Department ID for which printing is not disabled. For the Department ID and PIN, contact
your Administrator.
Setting the Department ID Management(P. 226)
Set the correct authentication information.
The client authentication information (key and certicate, user name and password, or CA certicate) is
not set correctly.
● Check the specied authentication method and authentication information (key and certicate, user name
and password, and CA certicate).
Conguring IEEE 802.1X Authentication Settings(P. 264)
Set the information necessary for authentication.
The IEEE 802.1X authentication has not been congured correctly.
● Congure the IEEE 802.1X correctly from the Remote UI.
Conguring IEEE 802.1X Authentication Settings(P. 264)
Size/Settings Mismatch
The paper size setting on the operation panel does not match the loaded paper size.
● Match the paper size setting specied in <Paper Settings> and the size of the paper that is actually loaded.
To use the loaded paper
Change the setting of <Paper Settings> to match the loaded paper size.
Specifying Paper Size and Type(P. 144)
● If printing from a computer, check whether the paper size setting in the printer driver matches the loaded
paper size.
To load paper without changing the settings
Load the paper with the size that is set to <Paper Settings>.
Loading Paper(P. 124)
● Check that the paper guides in the paper drawer are set in the correct position.
Loading Paper(P. 124)
Troubleshooting
488