56
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
[Example] Creating a tube as follows.
Cut length (40 mm)
Alignment (Left)
Pump Room
Margin (5 mm)
1
Press the [Seg Len] key.
2
Use [ ] or [ ] to select "Cut Length," and press the [Enter] key.
Cut Length
ɻɻ
Cut Length
Alignment
Plate Print Area
3
Use [ ] or [ ] to select "Specify," enter "40.0" (Cut Length), and then press
the [Enter] key.
The value can be set by entering numbers or
using arrow keys ([
]/[ ]).
Cut length can be entered in the range of 8 mm
t
o 150 mm (4 mm to 150 mm for label/plate
only) in 0.1 mm increments.
Press the [Enter] key to return to the character
input displa
y.
Cut Lengthɻ
ɻɻ
ɻ$XWRPDWLF
ɻ6SHFLI\ʁ40.0mm
ʨ 8.0 to 150.0mmʩ
4
Press the [Seg Len] key.
5
Use [ ] or [ ] to select "Alignment" and press the [Enter] key.
Cut Length
ɻɻ
Cut Length
Alignment
Plate Print Area
To Next Page
Loading...
