Canon MK5000 - Page 63

59
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
[Example] Create a plate as shown below.
4mm
A-12
1
Press the [Seg Len] key.
2
Press [ ] or [ ] to select "Cut Length," and then press the [Enter] key.
Cut Length
ɻɻ

Cut Length
Alignment
Plate Print Area
3
Use [ ] or [ ] to select "Specify," enter "4.0" (Cut Length), and then press
the [Enter] key.
󱾀
The value can be set by entering numbers or
using arrow keys ([
]/[ ]).
󱾀
The display returns to the character input
displa
y.
Cut Lengthɻ
ɻɻ

ɻAutomatic
ɻSpecify ʁ 4.0㎜
[ 4.0 to 150.0㎜ ]
4
Press the [Seg Len] key.
5
Use [ ] or [ ] to select "Alignment" and press the [Enter] key.
Cut Length
ɻɻ

Cut Length
Alignment
Plate Print Area
6
Use [ ] or [ ] to select "Centered," and press the [Enter] key.
󱾀
Press the [Enter] key to return to the character
input display.
󱾀
"×" will appear next to the alignments that
cannot be selec
ted.
Alignment
ɻɻ

Centered
Left
Right