[Output] Settings - [Exposure]
Setting Values Description
[Exposure] [Dark] You can adjust the settings for light areas and dark
areas on the print separately.
• When an area on the output must be darker,
then select a value of -1 to -3.
• When the area must be lighter, then select a val-
ue of 1 to 3.
[Light] • When the area must be darker, then select a val-
ue of -1 to -3.
• When an area on the output must be lighter,
then select a value of 1 to 3.
[Output] Settings - [Binding]
Setting Values Description
[Binding] [None] Here you can define the required number of sta-
ples. Furthermore you can define where you want
the staples with the [Location] option.
The available locations for one staple:
• [Top left]
• [Top right]
• [Bottom left]
• [Bottom right]
The available locations for two staples:
• [Left edge]
• [Top edge]
• [Bottom edge]
• [Right edge]
Check the preview for the result of the selection.
[1 staple]
[2 staples]
[Saddle stitching]
[Output] Settings - [Folding]
This option is only available when you have a folding unit connected.
Description of the Copy Job Settings
230
Chapter 7 - Carry Out Copy Jobs
Canon varioPRINT 135 Series
To Next Page
Loading...
