Canon varioPRINT 110 - Page 95

Step Action Remark
3 Repeat the steps 1 and 2 with the next
registration sheets.
4 The media registration is completed when
the control panel displays the message
[Remove the registration sheet from the
glass plate.]
Touch [Next].
5 The control panel displays the message
[Do you want to print the verification
chart?]. When you touch [Yes], the verifi-
cation chart is printed.
The automatic media registration is com-
pleted.
NOTE
The media specific registration
adjustment overwrites any au-
tomatic or manual media specif-
ic registration performed previ-
ously.
6
If the adjustment was successful, this icon
appears behind the media registered in
the media catalog in the Settings Editor.
7 When the following conditions apply, you
must enter the actual sheet size via the
manual media registration for this media.
• The media registration is not optimal
and
• The sheet is larger than 420 mm (16.5")
in X direction (feed direction) and larg-
er than 297 mm (11.7") in Z direction
(perpendicular to the feed direction).
See Registration Values on page 98.
If you do not enter the actual sheet size,
you will see a large deviation in front-to-
back side registration.
8 Only if the media registration is not opti-
mal, continue with the next option.
Print the verification chart to verify if the
media registration is optimal now.
Actions for Media-Specific Registration
94
Chapter 5 - Media Handling
Canon varioPRINT 135 Series