Model 201 Installation & Technical
8400-M117-O1 Rev D
nET2 (Netmask, Second Part)
The format for the Netmask is: ### . ### . ### . # (e.g., 255.255.252.0).
This parameter is the second part of the Netmask.
Press the F3/ key to view the current setting for the second part of
the Netmask. If the displayed setting is acceptable, press the F3/
key to save it. Otherwise, use the F2/ and F1/ keys to enter a new
setting and press the F3/ key to save the new setting. Allowable
values are: 000 through 255.
nET3 (Netmask, Third Part)
The format for the Netmask is: ### . ### . ### . # (e.g., 255.255.252.0).
This parameter is the third part of the Netmask.
Press the F3/ key to view the current setting for the third part of the
Netmask. If the displayed setting is acceptable, press the F3/ key to
save it. Otherwise, use the F2/ and F1/ keys to enter a new setting
and press the F3/ key to save the new setting. Allowable values are:
000 through 255.
nET4 (Netmask, Fourth Part)
The format for the Netmask is: ### . ### . ### . # (e.g., 255.255.252.0).
This parameter is the fourth part of the Netmask.
Press the F3/ key to view the current setting for the fourth part of the
Netmask. If the displayed setting is acceptable, press the F3/ key to
save it. Otherwise, use the F2/ and F1/ keys to enter a new setting
and press the F3/ key to save the new setting. Allowable values are:
000 through 255.
gate1= (Gateway Address, First Part)
The format for the gateway address is: # . # . # . # (e.g., 0.0.0.0). This
parameter is the first part of the address.
Press the F3/ key to view the current setting for the first part of the IP
address. If the displayed setting is acceptable, press the F3/ key to
save it. Otherwise, use the F2/ and F1/ keys to enter a new setting
and press the F3/ key to save the new setting. Allowable values are:
000 through 255.
To Next Page
Loading...