To Next Page

To Previous Page

Model 201 Installation & Technical

8400-M117-O1 Rev D

Page 69

EIP= (Enable Ethernet/IP)

Press the F3/  key to show the current setting. If the setting displayed is

acceptable, press the F3/  key again to save it. Otherwise, use the

F2/ key to toggle to a new setting and then press the F3/  key to save

it. Allowable settings are:

off

Off (Ethernet/IP is Disabled)

ON (Ethernet/IP is Enabled)

NOTE: If EIP= (Enable Ethernet/IP) is Enabled (on), the

following prompts, Output Weight as... and Output weight byte

order will be active.

For= (Output Weight as...)

Press the F3/  key to show the current setting. If the setting displayed

is acceptable, press the F3/  key again to save it. Otherwise, use the

F2/ key to toggle to a new setting and then press the F3/  key to save

it. Allowable settings are:

fLoAt

Output Weight as Float

int

Output Weight as Integer

ord= (Output Weight Byte Order)

Press the F3/  key to show the current setting. If the setting displayed

is acceptable, press the F3/  key again to save it. Otherwise, use the

F2/ key to toggle to a new setting and then press the F3/  key to save

it. Allowable settings are:

1234

4321

3412

2143



Cardinal 201 User Manual

Other manuals for Cardinal 201