Cardinal 825 - Page 58

8545-M838-O1 Rev D  825 Installation & Technical
52
SETUP AND CALIBRATION, CONT.
Interval:
With the Scale 1 - Calibration – General screen displayed the current setting for the
Interval: parameter will be shown. If the setting displayed is acceptable, proceed to
the next parameter. NOTE! If using multiples intervals, this is the low interval.
Otherwise, use the numeric keys to enter the interval (or minimum increment of weight
reading) and then press the  Down Arrow to advance to the next parameter or press
the ENTER key to save the new setting and return to the previous screen. Allowable
values are 1, 2, 5, 10, 20, 50 or 100.
Interval Dec:
With the Scale 1 - Calibration – General screen displayed the current setting for the
Interval Dec: parameter will be shown. If the setting displayed is acceptable,
proceed to the next parameter.
Otherwise, use the numeric keys to enter the interval decimal places and then press the
 Down Arrow to advance to the next parameter or press the ENTER key to save the
new setting and return to the previous screen. Allowable values are 0 to 5.
0 = #######
2 = #####.##
4 = ###.####
1 = ######.#
3 = ####.###
5 = ##.#####
Conv Units:
With the Scale 1 - Calibration – General screen displayed the current setting for the
Conv Units: parameter will be shown. If the setting displayed is acceptable, proceed
to the next parameter.
Otherwise, press the SPACE key to step through and select the Conv Units and then
press the  Down Arrow to advance to the next parameter or press the ENTER key to
save the new setting and return to the previous screen. Supported Conv Units are:
Conv Units Selections
lb (pounds)
tn (tons)
None
kg (kilograms
tonne (metric tons)
Custom


If Custom is selected for Conv Units:, an additional parameter (below the Conv
Units: parameter) and the conversion setup screen will be shown. Otherwise, proceed
to the Scale 1 - Calibration – Filtering screen.
Custom Label:
With Custom selected for Conv Units: the current setting for Custom label: will be
shown. If the setting displayed is acceptable, press the ENTER key to proceed to the
next screen or the Navigation Keys  Left Arrow to return to the previous screen.
Otherwise, use the alphanumeric keys to enter a new description for the Conv Units
Custom Label (up to 5 characters, e.g., Litre for Litre) and then press the ENTER key
to save the new setting and proceed to the next screen.