Casio QT-6000 Service Manual

— 34 —
[ 5 ] FLASH Check SUM test
[Function]
This test will check SUM test for FLASH is performed.
[Operation]
Operation : n 5 1 2 ST
n: 0  1 = One time check (can be omitted)
not 0 = Continuous check (To stop the test, press "ESC" key)
[LCD]
[PRINT]
FLASH 512
FLASH CHK SUM OK
END 512
FLASH 512
FLASH CHK SUM OK
END 512
[ 6 ] FLASH CLEAR WRITE/READ test
[Function]
The CLEAR & WRITE/READ test for FLASH is performed.
After deleting the memory by CLEAR, WRITE/READ test is performed.
Note: since this test cannot backup the program, you need to perform IPL again after the test.
When the memory in the FLASH memory is cleared (by the CLEAR test), the program is
cleared also.
[Operation]
Operation : n 6 1 2 ST
n: 0  1 = One time check (can be omitted)
not 0 = Continuous check (To stop the test, press "ESC" key)
[LCD]
NG and the address are displayed if WRITE cannot be done
normally.
NG and the address are printed if WRITE cannot be done
normally.
[PRINT]
FLASH 612
FLASH WR ERASE PGM OK
END 612
FLASH 612
FLASH WR ERASE PGM OK
END 612

Casio QT-6000 Specifications

General

Types of payment	Cash
Second display	Yes
Second display type	LED
Power source	AC
AC input voltage	120-240 V
Power consumption	1100 mA
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	311 mm
Width	343 mm
Height	288 mm
Weight	5300 g