— 7 —
2-1-3. How to flag clear the terminal (or INIT2)
Preparation:
1. All peripheral devices and this terminal should be turned off.
2. Check the connection of all peripheral devices (such as printer, display etc.) of this terminal.
3. Check the connection of this terminal to inline.
Operation:
4. Turn on all peripheral devices of this terminal.
5. Turn on this terminal with pressing the <DISP ON/OFF> key.
6. Press <OK> key.
FC
Copyright(C)2004
CASIO COMPUTER CO.,LTD.
All rights reserved.
ROM VER xxxxxx xxxx
CREATE xxxx-xx-xx xx:xx
QT-6000 Version x.xx
APL VER. xxxxxx xxxx
OK
7. Select “1. Flag Clear” and press <YES> key to flag clear.
or select “2.Init2” and press <YES> key and enter “8888888888” and <YES> key to Init 2.
2-2. SYSTEM INITIALIZATION
In this chapter shows how to install QT-6000 systems and peripherals.
2-2-1. How to load IPL (Initial Program Loading)
Normally, IPL is not necessary since the terminal has efficient programmable options to
meet your circumstances.
In some cases, you need to change the application program to meet your requirements, the
IPL is necessary to download the application program to the terminal.
To load IPL, there are two methods:
1) From PC to a terminal via RS-232C
2) From CF card to a terminal
To Next Page
Loading...
